User Manual
Table Of Contents
- Rider's manual S 1000 RR
- General instructions
- General views
- Status indicators
- Operation
- Ignition switch/steering lock
- Emergency off switch (kill switch)
- Intelligent emergency call
- Lights
- Hazard warning lights system
- Turn indicators
- Dynamic Traction Control (DTC)
- Riding mode
- Cruise-control system
- Hill Start Control
- Gearshift light
- Anti-theft alarm (DWA)
- Tyre pressure monitoring (RDC)
- Heated handlebar grips
- On-board computer
- Front and rear seats
- TFT display
- Adjustment
- Riding
- On the race track
- Displays for racing
- LAPTIMER
- Vehicle settings for racing
- RACE PRO riding modes
- Launch Control
- Pit Lane Limiter
- DTC
- Chassis and suspension settings for racing
- Removing and installing mirrors
- Removing and installing number-plate carrier
- Switching off ABS when riding on the race track
- Deactivating intelligent emergency call when riding on the race track
- Gearshift-pattern reverser
- Engineering details
- Maintenance
- Accessories
- Care
- Technical data
- Service
- Appendix
- Index
Remove screws 1 and 2.
Unclip left and right rear trim
panels carefully in the direc-
tion of arrow.
Carefully unclip left and right
rear trim panel 1, first horizont-
ally 2, then vertically 3.
Push the rider's seat cover 1
forward slightly on the seat
cushion surface and expose
tab 2.
Remove bolt 3.
Lift up the rider's seat 1 at the
rear and unhook fixing 4.
Place the seat, upholstered
side down, on a clean surface.
Remove bolts 1 and 3 from
tail-hump trim panel 2.
Carefully unclip panels 4 in
the direction of arrow.
10
199
z
Maintenance