User Manual
Table Of Contents
- Rider's manual S 1000 RR
- General instructions
- General views
- Status indicators
- Operation
- Ignition switch/steering lock
- Emergency off switch (kill switch)
- Intelligent emergency call
- Lights
- Hazard warning lights system
- Turn indicators
- Dynamic Traction Control (DTC)
- Riding mode
- Cruise-control system
- Hill Start Control
- Gearshift light
- Anti-theft alarm (DWA)
- Tyre pressure monitoring (RDC)
- Heated handlebar grips
- On-board computer
- Front and rear seats
- TFT display
- Adjustment
- Riding
- On the race track
- Displays for racing
- LAPTIMER
- Vehicle settings for racing
- RACE PRO riding modes
- Launch Control
- Pit Lane Limiter
- DTC
- Chassis and suspension settings for racing
- Removing and installing mirrors
- Removing and installing number-plate carrier
- Switching off ABS when riding on the race track
- Deactivating intelligent emergency call when riding on the race track
- Gearshift-pattern reverser
- Engineering details
- Maintenance
- Accessories
- Care
- Technical data
- Service
- Appendix
- Index
Check the oil level only
after a lengthy ride or when
the engine is at operating
temperature.
Make sure the engine is at op-
erating temperature and hold
the motorcycle upright.
Allow the engine to idle for one
minute.
Switch off the ignition.
Wait five minutes for the oil to
drain into the oil pan.
NOTICE
To protect the environment,
BMW Motorrad recommends
occasionally checking the
engine oil after a journey of at
least 50 km.
Check the oil level in the
display 1.
Engine oil, specified level
Between MIN and MAX
marks
10
180
z
Maintenance