User Manual
Table Of Contents
- Rider's manual S 1000 RR
- General instructions
- General views
- Status indicators
- Operation
- Ignition switch/steering lock
- Emergency off switch (kill switch)
- Intelligent emergency call
- Lights
- Hazard warning lights system
- Turn indicators
- Dynamic Traction Control (DTC)
- Riding mode
- Cruise-control system
- Hill Start Control
- Gearshift light
- Anti-theft alarm (DWA)
- Tyre pressure monitoring (RDC)
- Heated handlebar grips
- On-board computer
- Front and rear seats
- TFT display
- Adjustment
- Riding
- On the race track
- Displays for racing
- LAPTIMER
- Vehicle settings for racing
- RACE PRO riding modes
- Launch Control
- Pit Lane Limiter
- DTC
- Chassis and suspension settings for racing
- Removing and installing mirrors
- Removing and installing number-plate carrier
- Switching off ABS when riding on the race track
- Deactivating intelligent emergency call when riding on the race track
- Gearshift-pattern reverser
- Engineering details
- Maintenance
- Accessories
- Care
- Technical data
- Service
- Appendix
- Index
Install service adapters (83 30
2 152 841) 1 in the rear wheel
swinging arm on left and right
and tighten to the specified
torque.
Swinging-arm adapter to
rear wheel swinging arm
20 Nm
Turn brackets 2 with the long
sides facing outwards.
Adjust adapters 3 to the width
of the service adapters used in
the rear wheel swinging arm.
Set the height of the rear-
wheel stand to raise the rear
wheel slightly clear of the
ground.
Engage the rear-wheel stand in
the rear wheel swinging arm
and apply even pressure to
push it down to the ground.
Engine oil
Checking engine oil level
ATTENTION
Misinterpretation of oil level
reading, because oil level is
temperature-dependent (the
higher the temperature, the
higher the oil level)
Engine damage
10
179
z
Maintenance