User Manual
Table Of Contents
- Rider's manual S 1000 RR
- General instructions
- General views
- Status indicators
- Operation
- Ignition switch/steering lock
- Emergency off switch (kill switch)
- Intelligent emergency call
- Lights
- Hazard warning lights system
- Turn indicators
- Dynamic Traction Control (DTC)
- Riding mode
- Cruise-control system
- Hill Start Control
- Gearshift light
- Anti-theft alarm (DWA)
- Tyre pressure monitoring (RDC)
- Heated handlebar grips
- On-board computer
- Front and rear seats
- TFT display
- Adjustment
- Riding
- On the race track
- Displays for racing
- LAPTIMER
- Vehicle settings for racing
- RACE PRO riding modes
- Launch Control
- Pit Lane Limiter
- DTC
- Chassis and suspension settings for racing
- Removing and installing mirrors
- Removing and installing number-plate carrier
- Switching off ABS when riding on the race track
- Deactivating intelligent emergency call when riding on the race track
- Gearshift-pattern reverser
- Engineering details
- Maintenance
- Accessories
- Care
- Technical data
- Service
- Appendix
- Index
General instructions
The "Maintenance" chapter de-
scribes straightforward proced-
ures for checking and replacing
certain wear parts.
Special tightening torques are lis-
ted as applicable. The tightening
torques for the threaded fasten-
ers on your vehicle are listed in
the section entitled "Technical
data".
You will find information on more
extensive maintenance and repair
work in the Repair Manual on
DVD for your vehicle, which is
available from your authorised
BMW Motorrad Retailer.
Some of the work calls for spe-
cial tools and a thorough know-
ledge of the technology involved.
If you are in doubt, consult a
specialist workshop, preferably
your authorised BMW Motorrad
Retailer.
Toolkit
1 Lever
without Dynamic Damp-
ing Control (DDC)
OE
Adjusting spring preload
for rear wheel ( 109).
with Race package
OE
or
with M Package
OE
Adjusting riding height
at the traction strut
( 115).
2 Open-ended spanner
Width across flats 10/13
Removing battery
( 205).
2 Adjusting spring preload
for front wheel ( 108).
with Dynamic Damping
Control (DDC)
OE
Adjusting spring preload
for rear wheel ( 110).
3 Reversible screwdriver
blade
Slotted bit and Torx T25
Removing and installing
trim panel components.
Removing front seat
( 81).
without Dynamic Damp-
ing Control (DDC)
OE
Adjusting compression-
stage damping for front
wheel ( 111).
without Dynamic Damp-
ing Control (DDC)
OE
Adjust the rebound-
stage damping for front
wheel ( 112).
10
176
z
Maintenance