User Manual
Table Of Contents
- Rider's manual S 1000 RR
- General instructions
- General views
- Status indicators
- Operation
- Ignition switch/steering lock
- Emergency off switch (kill switch)
- Intelligent emergency call
- Lights
- Hazard warning lights system
- Turn indicators
- Dynamic Traction Control (DTC)
- Riding mode
- Cruise-control system
- Hill Start Control
- Gearshift light
- Anti-theft alarm (DWA)
- Tyre pressure monitoring (RDC)
- Heated handlebar grips
- On-board computer
- Front and rear seats
- TFT display
- Adjustment
- Riding
- On the race track
- Displays for racing
- LAPTIMER
- Vehicle settings for racing
- RACE PRO riding modes
- Launch Control
- Pit Lane Limiter
- DTC
- Chassis and suspension settings for racing
- Removing and installing mirrors
- Removing and installing number-plate carrier
- Switching off ABS when riding on the race track
- Deactivating intelligent emergency call when riding on the race track
- Gearshift-pattern reverser
- Engineering details
- Maintenance
- Accessories
- Care
- Technical data
- Service
- Appendix
- Index
chafe points using adhesive
tape.
NOTICE
Use the M Cover Kit from
BMW Motorrad to cover the
resulting bolt holes and re-
establish fastening.
Position air inlet flap 1 and clip
in at the top 2.
Position windscreen in the dir-
ection of arrow.
Install bolts 1 and 2.
Install mirror
Place the motorcycle on its
stand on firm, even ground.
Remove trim panel mounting.
Remove screws 1 and 2.
Remove windscreen in the dir-
ection of arrow.
Unclip air inlet flap at the top
in the direction of arrow and
remove downwards.
8
149
z
On the race track