User Manual
Table Of Contents
- Rider's manual S 1000 RR
- General instructions
- General views
- Status indicators
- Operation
- Ignition switch/steering lock
- Emergency off switch (kill switch)
- Intelligent emergency call
- Lights
- Hazard warning lights system
- Turn indicators
- Dynamic Traction Control (DTC)
- Riding mode
- Cruise-control system
- Hill Start Control
- Gearshift light
- Anti-theft alarm (DWA)
- Tyre pressure monitoring (RDC)
- Heated handlebar grips
- On-board computer
- Front and rear seats
- TFT display
- Adjustment
- Riding
- On the race track
- Displays for racing
- LAPTIMER
- Vehicle settings for racing
- RACE PRO riding modes
- Launch Control
- Pit Lane Limiter
- DTC
- Chassis and suspension settings for racing
- Removing and installing mirrors
- Removing and installing number-plate carrier
- Switching off ABS when riding on the race track
- Deactivating intelligent emergency call when riding on the race track
- Gearshift-pattern reverser
- Engineering details
- Maintenance
- Accessories
- Care
- Technical data
- Service
- Appendix
- Index
At every third refuelling
stop
Checking engine oil level
( 179).
Checking front brake pad thick-
ness ( 182).
Checking rear brake pad thick-
ness ( 183).
Checking brake-fluid level, front
brakes ( 184).
Checking the brake-fluid level,
rear brakes ( 185).
Check coolant level ( 187).
Starting
Starting the engine
Switch on the ignition.
Pre-Ride-Check is performed.
( 123)
ABS self-diagnosis is in pro-
gress. ( 123)
DTC self-diagnosis is in pro-
gress. ( 124)
Select neutral or, if a gear is
engaged, pull the clutch lever.
NOTICE
You cannot start the motorcycle
with the side stand extended and
a gear engaged. The engine will
switch itself off if you start it with
the gearbox in neutral and then
engage a gear before retracting
the side stand.
For a cold engine start and low
temperatures: pull clutch.
with M battery
OE
Low temperatures can impact
on the starting response.
Press the starter button 1.
NOTICE
The start attempt is automatic-
ally interrupted if battery voltage
is too low. Recharge the battery
before you start the engine, or
use jump leads and a donor bat-
tery to start.
See the subsection on jump
starting in "Maintenance" for
more details.
The engine starts.
Consult the troubleshooting
chart below if the engine re-
fuses to start. ( 224)
7
122
z
Riding