User Manual
Table Of Contents
- Rider's manual S 1000 RR
- General instructions
- General views
- Status indicators
- Operation
- Ignition switch/steering lock
- Emergency off switch (kill switch)
- Intelligent emergency call
- Lights
- Hazard warning lights system
- Turn indicators
- Dynamic Traction Control (DTC)
- Riding mode
- Cruise-control system
- Hill Start Control
- Gearshift light
- Anti-theft alarm (DWA)
- Tyre pressure monitoring (RDC)
- Heated handlebar grips
- On-board computer
- Front and rear seats
- TFT display
- Adjustment
- Riding
- On the race track
- Displays for racing
- LAPTIMER
- Vehicle settings for racing
- RACE PRO riding modes
- Launch Control
- Pit Lane Limiter
- DTC
- Chassis and suspension settings for racing
- Removing and installing mirrors
- Removing and installing number-plate carrier
- Switching off ABS when riding on the race track
- Deactivating intelligent emergency call when riding on the race track
- Gearshift-pattern reverser
- Engineering details
- Maintenance
- Accessories
- Care
- Technical data
- Service
- Appendix
- Index
Mirrors
Adjusting mirrors
Pivot the mirror to the correct
position by pressing gently at
the edge of the glass.
Headlight
Headlight adjustment for
right- or left-hand traffic
This motorcycle has a
symmetric-beam low-beam
headlight. If the motorcycle
is ridden in a country where
the opposite rule of the road
applies, its symmetric low-
beam headlight means that
no measures are necessary to
prevent the headlight beam from
dazzling oncoming traffic.
Headlight beam throw and
spring preload
The headlight beam throw gen-
erally remains constant by adjust-
ment of the spring preload to the
load status.
NOTICE
If there are doubts about the cor-
rect headlight beam throw, have
the setting checked by a special-
ist workshop, preferably an au-
thorised BMW Motorrad dealer.
Brakes
Adjust the handbrake
lever
WARNING
Adjusting the brake lever
while riding
Risk of accident
Do not attempt to adjust the
brake lever unless the motor-
cycle is at a standstill.
Turn adjuster knob 1 to the
desired position.
6
106
z
Adjustment