Specification
Features
• Cleaner Operation - The valve operation cuts oil ow almost instantly when power is cut to the solenoid coil, eliminating
coasting stops that can cause soot formation on shut-down. The Beckett GeniSys and other pre-purge enabled controls or
Beckett’s PD timer work well with the CleanCut pump to bring the burner up to full speed before light-o. See illustration below.
• More Reliable - There are fewer moving
parts compared to conventional pumps and fewer
troublesome oil ttings to cause problems. In
addition, all of the moving parts in the CleanCut
pumps have been in use for years in both the US
and in Europe.
• Higher Capacity - The unique design of
the Cleancut pumps deliver up to 4 gallons per
hour at 100 psi. (Note that applications above 3
gph will require an additional valve to meet UL
requirements.)
• Reduced Load on Motor - Reduces load
on the motor during start-up.
PF10323 PF10322 PF10422
Description
The Beckett CleanCut family of pumps has been developed to combine the benets of a solenoid valve and
the superior lift capabilities of traditional American pumps. We have added an additional supplier to this product
oering, while keeping the eld proven features and performance benets that have become the standard of
the industry.
The Beckett p/n PF10422 is a two-stage pump for use where lift requirements exceed 12’. The PF10422 is a
direct replacement for Suntec B2VA-8216 when solenoid cuto is desired. Note: A GeniSys control with pre-
purge or a Beckett PD Timer will be needed for proper burner operation. See reverse for instructions.
Oil Pumps
Product Sheet