Installation guide

Burner Contro|s
Figure 11a. = Interrupted ignition, valve-on delay
only (no motor-off delay)
Figure 11b. = Interrupted ignition, valve-on delay
and motor-off delay
L1.
L2 SAFETY AND
OPERATING
LIMITS
IGNITER
THERMOSTAT
CAD CELL
L1 - LIMIT
JUMPER
TR_TW
TR-TW TERMINALS
LOCATED ON OPPOSITE
SIDE OF CONTROL
L1
L2
THERMOSTAT
OIL M_ f TR
TR-TW TERMINALS
LOCATED ON OPPOSITE
SIDE OF CONTROL
CAD CELL
Reset Button Operation
Table 2 explains what action the control will take when the reset button is pressed for different lengths of time
during the various burner operating states.
Lockout
Valve-on Delay,Trial for
Ignition, Ignition Carryover
Table 2 - Reset Button 0 _eration
Pushing the reset button will:
--- Button Click Button Hold Button Hold
(press < 1 second) (press > 1 second) (press 15+ seconds)
Reset from Restricted (Hard)
Reset from Soft Lockout
Lockout
Run (igniter is shut off)
Motor-Off Delay,
Standby
Pump Prime
Go to Pump Prime (see
"Primingthe Pump" above)
Yellow light flashes to indicate
cad cel resistance. See "Cad
Cell Resistance Indicator"for
table of resistance values.
No action
Disable the Burner:
Any time the burner is running,
press and hold the reset button
to disable the burner. The
burner will remain off as long
as the button is held.
Enables Pump Priming:
After the reset button has been
held for 15 seconds, the button
can then be clicked during the
next ignition sequence to enter
Pump Prime mode.
No action Exit Pump Prime mode and return to Standby
Table 3 =Status Lights
Red
Green
Yellow
Restricted (Hard) Lockout
Flame Sensed during normal operation (Could
be stray light during standby)
Control is in Pump Prime mode or
Reset button currently held for 15+ seconds.
Soft Lockout
Recycle
Cad Cell resistance. See "Cad Cell Resistance
Indicator" on page 8 for a table of resistance values.
Page 16 6104BAFG R04