Operating instructions

GB
DE
21
Now press the programming button on the master transmitter again, this time
keeping it pressed for 10 seconds.
The shutter/awning/blind will ‘nod’ to confi rm.
All transmitters (except master transmitter) have been successfully deleted
from the receiver.
Overwriting the master transmitter
Turn off the power supply to the VC420A and switch back on after 5 seconds.
The VC420A goes into programming mode for 3 minutes.
Note
To ensure that the new master transmitter is programmed in the de-
sired VC420A only, all other receivers which are connected to the same
power supply must be deactivated from the programming mode. To do
so, after switching back on the power supply, execute a control or stop
command using the transmitter for the given receivers.
Now press the programming button of the new master transmitter for 10 sec-
onds.
The shutter will “nod” to confi rm.
The new master transmitter has been programmed and the old master transmit-
ter deleted.
Intermediate position
Note
The intermediate position can be set at any given position and lies be-
tween the upper and lower fi nal positions of the shutter. The intermedi-
ate position can only be set after the two fi nal positions have been set.
The shutter is adjusted into the intermediate position from the upper
fi nal position.
Setting the intermediate position
1. Adjust the shutter from the upper fi nal position into the desired intermediate
position.
2. Now press and hold the STOP button. Within 3 seconds also press the DOWN
button and keep both buttons pressed.
The shutter will “nod” to confi rm.
The intermediate position has been stored.
Programming