Installation guide

Subject to errors and technical changes 49 Copyright by Harman/Becker GmbH, D-76303 Karlsbad
Installation instructions for the TriVision Car Docking Station
10. Routing wiring / Installing antennas
• Route the audio/video in, audio/video out (optional), power supply and both antenna cables in the required positions.
The cable ends and small connectors of the audio/video in and audio/video out cables are protected by small plastic
bags. Only remove these once you have routed the cables in the vehicle.
• When routing the antenna cables, please refer to the instructions contained in “Installation of both antennas” on page
51.
• Ensure strain relief of the audio/video in and audio/video out ca-
bles at the mounting plate (B) using the two cable clips provided.
Make sure that the cable screening is clamped in the cable clips.
In order to avoid short-circuits and malfunctions, install the cables so that they cannot be pinched, kinked, chafed
or detached.
When routing the audio/video in cable, ensure that you route the cable end with the housing grommet towards the
adapter box (E). The end to be routed towards the Car Docking Station is marked with yellow tape.