Installation guide

Subject to errors and technical changes 47 Copyright by Harman/Becker GmbH, D-76303 Karlsbad
Installation instructions for the TriVision Car Docking Station
9.11 the mounting plate to the support struts
• Drill holes with the correct diameter (for the sheet-metal screws be-
ing used) in the holes marked on the roof strut, see 9.8 on page 45.
• Fasten the mounting plate (B) with at least two sheet-metal
screws. Use the correct spacers as required (as determined under
9.9 on page 45).
When drilling and then tightening the mounting plate, ensure
that no damage is caused to the roof (e.g. excessively long
screws).
The mounting plate (B) must be detached again for the purpose
of routing the wiring and fastening the cable clips for the audio/
video in/out cables.