Installation guide

Subject to errors and technical changes 45 Copyright by Harman/Becker GmbH, D-76303 Karlsbad
Installation instructions for the TriVision Car Docking Station
9.8 Marking the drill holes for the main attachment
• Position the mounting plate (B) correctly between the headliner
and the roof strut.
• The two elevated recesses are used (elevated part against the roof
strut) for subsequently screwing on the mounting plate (B).
• Mark the position of the drill holes on the support strut.
9.9 Determining the distance between the mounting plate and the strut/roof
• In order to maintain the distance from the support strut on the vehicle and the vehicle headliner, determine whether
spacers are required, as described under 9.7 on page 44. For this purpose, subtract the mounting plate thickness of
4 mm from the distance measured under 9.7 on page 44. The result of the subtraction gives the necessary height of
the spacers.