Installation guide

Subject to errors and technical changes 43 Copyright by Harman/Becker GmbH, D-76303 Karlsbad
Installation instructions for the TriVision Car Docking Station
9.4 Determining the central axis of the vehicle
• Determine the central axis by measuring the width of the vehicle. Mark the central axis. This permits you to attach
the mounting plate (B) centrally.
9.5 Marking out the cutout for the mounting plate
• Hold the mounting plate (B) in the correct position on the headlin-
er. Ensure that it will subsequently be possible to screw the main
attachment to the
roof strut . Also ensure that you hold the mount-
ing plate (B) according to the markings on the plate (front/rear).
• Mark out the size of the cutout with a pen. The size of the cutout
is indicated by means of the slot running approx 1 cm from the
edge of the mounting plate (B). I.e., the subsequent cutout in the
headliner is a little smaller than the mounting plate.