Operation Manual

54
>>> NAVIGATION MODE
> D
> GB
> F
> I
> E
> P
> NL
> DK
> S
> N
> FIN
> TR
> GR
> PL
> CZ
> H
> SK
The Reset button
You can reset the navigation settings to
their factory settings.
The settings will then be reset. The fast ac-
cess mode data, stored routes and home
address are retained.
> Press the
Reset button.
> Press the
Yes button.
The navigation settings are reset to their
factory settings.
Traffic announcements
using TMC*
Provided the TMC antenna is connected,
your Traffic Assist can receive traffic an-
nouncements (TMC announcements)
from radio stations.
Traffic announcements are transmitted by
radio stations via the TMC (Traffic Mes-
sage Channel) in addition to the radio
programme and are received and analysed
by the navigation system. Receiving traffic
announcements is free of charge.
The Traffic Assist constantly checks
whether there are any relevant announce-
ments for the route that has been set. All
traffic problems that have been received
are shown on the map.
If the continuous checks determine that a
traffic announcement is relevant to route
guidance, the unit can automatically re-
calculate a new route to the destination
(See “The TMC button*” on page 49.)
Note:
TMC is not available in all countries
(currently only Belgium, Germany, Den-
mark, France, Italy, the Netherlands,
Austria, Sweden, Switzerland and Spain).
Note:
As the traffic announcements are trans-
mitted by radio stations, we cannot as-
sume responsibility for the completeness
or accuracy of the announcements.
Austria: The location and event code was
made available by ASFINAG and BM-
VIT.
*Applies only to the Traffic Assist Z 099