Operation Manual

29
General operations
Transferring using the USB
port
The USB port is used to link the Traffic
Assist Highspeed II directly to a perso-
nal computer.
For transfers, the Microsoft
®
Active Sync program must be installed
on the computer. This is available free-
of-charge from the manufacturer.
The link then involves several steps:
! switch off Traffic Assist Highspeed II.
! link the Traffic Assist Highspeed II
and computer using the USB cable.
! switch the Traffic Assist Highspeed II
back on.
ActiveSync automatically sets up a link
to the Traffic Assist Highspeed II.
Transferring maps
The installation software from the DVD
should be used for the transfer. This in-
volves the following stages:
! switch off Traffic Assist Highspeed II.
! remove memory card and plug into an
SD card reading device or the use the
USB cable to connect the Traffic As-
sist Highspeed II to the computer.
! boot up the computer and insert the
DVD.
! use the installation program to transfer
the map required.
! slide the memory card back into the
Traffic Assist Highspeed II or correct-
ly remove the USB cable.
! switch the Traffic Assist Highspeed II
back on. The new map is available
right away
Transferring pieces of music
and pictures
Since the map data takes up virtually all
the 1GB memory capacity of the memo-
ry card supplied, pictures and music
should be saved on to another SD card.
The files can be transferred via a card
reader or the USB connection.
5017
Note:
Use obvious folder names because the-
se will help you later when you are
trying to find the file you want in the
Traffic Assist Highspeed II.