User manual
Table Of Contents
- Contents
- Warranty
- Safety instructions
- The Navigation device
- Overview of the scope of Delivery
- Overview of the navigation device
- General operation
- Maintenance and care
- Battery quality declaration
- Display quality declaration
- Start-up
- Power supply
- TMC antenna (depending on the model)
- GPS antenna
- Cable for vehicle integration (depending on model, optional)
- Cable for rear view camera (depending on the model, optional)
- Memory card
- Unit bracket
- Switching the Navigation device on/off
- Basic information about the touch screen
- Basic information about the menus
- Content Manager
- Transferring pictures
- Faults
- Download manager (model dependent)
- Transferring pictures
- Faults
- Navigation Mode
- What is navigation?
- Selecting Navigation
- Last destinations list
- The New destination menu
- Navigation settings
- The Map view button
- The Route overview button
- The Guidance info button
- The Route options button
- The TMC or Traffic button (model dependent)
- The Traffic Button (model dependent)
- The Voice guidance button
- The Warnings button
- The Blocked roads button
- The Vehicle data button
- The Format button
- The Time button
- The Reset button
- Traffic announcements using TMC (depending on the model)
- Live Traffic – Traffic Announcements via Data Connection (model dependent)
- The map display
- The Route overview
- SituationScan
- Map display options
- Supplementary functions for trucks and mobile homes (selected models only)
- Other additional functions (only selected models)
- Telephone mode
- Calling up the telephone mode (only selected models)
- Telephone menu (only selected models)
- Telephone calls
- Bluetooth settings (model dependent)
- Telephone settings
- Data settings / Bluetooth Tethering (model dependent)
- Audio Out settings (model dependent)
- Tools
- Settings
- Wi-Fi® settings (model dependent)
- Technical terminology
- index
- Model overview and technical specifications
- NOTICE
52
>>> NAVIGATION MODE
If the route guidance is already running
you will be asked whether the new
destination should replace the old
destination or if the new destination
should be regarded as a waypoint.
> Select between
Add as stopover, Add
as new destination
or Replace old
destination
.
If the route guidance is already running
and a waypoint has already been entered
you will be asked whether the new
destination should replace the old
destination or the waypoint.
> Select
Replace stopover or Replace
old destination
.
Note:
The symbols above the progress bar
refer to restrictions that you may have
activated (e.g. unpaved roads, toll
roads).
Note:
If there is no GPS signal when the route
is calculated, the following will be
displayed:
When a GPS signal is available, the route
calculation will start automatically.
When the
Last position button is
pressed, the last known position is used
and the route calculated from this
position.