User manual
Table Of Contents
- Contents
- Warranty
- Safety instructions
- The Navigation device
- Overview of the scope of Delivery
- Overview of the navigation device
- General operation
- Maintenance and care
- Battery quality declaration
- Display quality declaration
- Start-up
- Power supply
- TMC antenna (depending on the model)
- GPS antenna
- Cable for vehicle integration (depending on model, optional)
- Cable for rear view camera (depending on the model, optional)
- Memory card
- Unit bracket
- Switching the Navigation device on/off
- Basic information about the touch screen
- Basic information about the menus
- Content Manager
- Transferring pictures
- Faults
- Download manager (model dependent)
- Transferring pictures
- Faults
- Navigation Mode
- What is navigation?
- Selecting Navigation
- Last destinations list
- The New destination menu
- Navigation settings
- The Map view button
- The Route overview button
- The Guidance info button
- The Route options button
- The TMC or Traffic button (model dependent)
- The Traffic Button (model dependent)
- The Voice guidance button
- The Warnings button
- The Blocked roads button
- The Vehicle data button
- The Format button
- The Time button
- The Reset button
- Traffic announcements using TMC (depending on the model)
- Live Traffic – Traffic Announcements via Data Connection (model dependent)
- The map display
- The Route overview
- SituationScan
- Map display options
- Supplementary functions for trucks and mobile homes (selected models only)
- Other additional functions (only selected models)
- Telephone mode
- Calling up the telephone mode (only selected models)
- Telephone menu (only selected models)
- Telephone calls
- Bluetooth settings (model dependent)
- Telephone settings
- Data settings / Bluetooth Tethering (model dependent)
- Audio Out settings (model dependent)
- Tools
- Settings
- Wi-Fi® settings (model dependent)
- Technical terminology
- index
- Model overview and technical specifications
- NOTICE
28
>>> GENERAL OPERATION
Basic information about the
touch screen
The Navigation device is fitted with a
touch screen.
Operation
When you touch a button on the touch
screen, the button in question is briefly
shown outlined in red to confirm the
selection.
If you touch a button that is not active at
the moment, a short signal tone sounds.
Calibration (model dependent)
A calibration can only be carried out on
devices with resistive display, devices
with capacitive display do not have to be
calibrated.
If the touch screen responds
inaccurately, a calibration must be
carried out.
The calibration function is started from
the menu (see also page 142).
Note:
We recommend that you place the
Navigation device in sleep mode in the
event of short interruptions to operation
(of up to a week).
This significantly reduces the switch-on
time and the Navigation device finds the
satellites required for navigation much
faster.
If route guidance was active when sleep
mode is activated, it is automatically
resumed if the Navigation device is
switched back on again within approx.
4hours.
If the device cannot be switched off
anymore or no longer works reliably, it
is possible to switch off the device
completely by pressing the button on
the top for longer than 7 seconds.
Note:
To ensure that the display's surface is
not damaged, you may only touch it with
your fingers or a blunt, non-smearing
object.