User manual

26
>>> GENERAL OPERATION
Adjusting the unit holder’s position
> Loosen the fastening screws and
until the carrier plate can be
moved without using excessive force.
> Move the carrier plate to the
required position and hold it in this
position.
> Tighten the fastening screws and
sufficiently so that the Navigation
device is held securely in place when
the vehicle is in motion.
Attaching the Navigation device
> Position the Navigation device with the
attachment point on the bottom of the
housing, onto the carrier plate .
> Without using excessive force, press
the Navigation device onto the carrier
plate . The Navigation device locks
into place.
Removing the Navigation device
Press the button on the top of the
carrier plate . This unlocks the
Navigation device which can be removed
from the carrier plate.
Devices with magnetic holders
The unlocking button is not present.
First place the navigation device with the
upper mounting point onto the carrier
plate and fold down the navigation
device. The magnet holds the navigation
device securely on the carrier plate. To
remove the navigation device, first take it
off from the carrier plate at the bottom.
Switching the Navigation device
on/off (model dependent)
With the ON/OFF switch (I/O) you can
switch the Navigation device on or off
completely.
With the button on the upper side of
the Navigation device you can switch the
device to sleep mode or switch it from
sleep mode again.
For devices without the button on the
underside (model dependent): With the
button you can switch the device off,
on or to the sleep mode.
4
5
6
6
4
5
6
6
7
6
7
6
1
2
1
2
1
2