Operating instructions

9
5a)
5b)
5) Setting the end limits
Note
The end limits can only be set via the master transmitter. The axle direction setting must be correct. When
the end limits are being set, the tubular drive remains in lock-in mode. The lower end limit must always be
programmed rst. When setting the upper end limit, it is important to ensure that the shutter is securely in
the guide rails.
There are 4 possible ways to set the end limits:
Action Response
to 5a) Lower position to upper position without stopper
Note
For this end limit setting there is no automatic shutter curtain ad-
justment.
Adjust the shutter into the desired lower
limit position.
First press and hold the learn button.
Within 3 seconds also press the DOWN
button and hold both buttons.
The tubular drive makes a “clack”
sound to conrm.
Then adjust the shutter into the desired
upper limit position.
First press and hold the learn button.
Within 3 seconds also press the UP but-
ton and hold both buttons.
The tubular drive makes a “clack”
sound to conrm.
The end limits have been set.
5c)
a) Lower position to upper position without stopper
b) Lower position to upper stopper
c) Anti-lifting device at the lower limit to upper position without stopper
d) Anti-lifting device at the lower limit to upper stopper
to 5b) Lower position to upper stopper
Adjust the shutter into the desired lower
limit position.
First press and hold the learn button.
Within 3 seconds also press the DOWN
button and hold both buttons.
The tubular drive makes a “clack”
sound to conrm.
Then move the shutter up towards the
permanent upper stopper.
The tubular drive switches off automati-
cally.
The end limits have been set.
to 5c) Anti-lifting device at the lower limit to upper position without stop-
per
Adjust the shutter downwards until they
reach the lower limit position.
The tubular drive switches off automati-
cally.
Then adjust the shutter into the desired
upper limit position
First press and hold the learn button.
Within 3 seconds also press the UP but-
ton and hold both buttons.
The tubular drive makes a “clack”
sound to conrm.
The end limits have been set.
Clack
Clack
Clack
Clack