Operating instructions

13
11a)
11b)
12a)
12) Overwriting the master
11) Deleting transmitters
11a) Deleting transmitters individually
Note
The master transmitter which was programmed in point 3) cannot
be deleted. It can only be overwritten (see Point 12).
Press the learn button on the master
transmitter for 3 seconds.
The tubular drive makes a “clack”
sound to conrm.
Now press the learn button of the trans-
mitter to be deleted for 3 seconds.
The tubular drive makes a “clack”
sound to conrm.
Then press the learn button of the
transmitter to be deleted for a further
10 seconds.
The tubular drive makes a “clack-clack”
sound to conrm.
The transmitter has been deleted from
the tubular drive.
11b) Deleting all transmitters (except master transmitter)
Press the learn button on the master
transmitter for 3 seconds.
The tubular drive makes a “clack”
sound to conrm.
Now press the learn button on the mas-
ter transmitter for a further 3 seconds.
The tubular drive makes a “clack”
sound to conrm.
Now press the learn button on the mas-
ter transmitter for a further 10 seconds.
The tubular drive makes a “clack-clack”
sound to conrm.
All transmitters (except the master
transmitter) have been deleted from
the receiver.
12a) Activating the tubular drive programme mode by switching on the
power supply
The tubular drive goes into programme
mode for 3 minutes.
Now press the learn button of the new
master transmitter for 10 seconds.
The tubular drive makes a “clack-clack”
sound to conrm.
The new master transmitter has been
programmed and the old master trans-
mitter has been deleted.
Switch off the tubular drive’s power
supply and switch back on after 5 sec-
onds.
There are 2 ways to overwrite the master transmitter:
a) Activate tubular drive programme mode by switching on the power supply
b) Activate tubular drive programme mode using the radio switch
Note
To ensure that the new master transmitter is programmed into the
desired tubular drive only, all other tubular drives which are con-
nected to the same power supply must be deactivated from the
programme mode. To do so, after switching back on the power
supply, execute a control or stop command using the transmitter
for the given drives or adjust the radio switch from the inner to the
outer position. If the radio switch is already in this position, slide
the switch inwards and then back to the outer position.
Action Response
Clack
Clack
Clack
Clack
Clack
Clack
Clack
Clack
Clack
Clack
Mains connection
Motor cable
blue
black
brown
black
blue
green/
yellow
green/
yellow