Installation manual

61
• Disconnect the connecting cable from the power prior to installation.
• Always comply with regulations of local energy supply companies and VDE 100 provisions for wet
and damp rooms during installation.
• Keep people out of the system’s range of movement.
• Only use in dry rooms (exceptions: VCJ470, VC410, VC510, SWC510).
• Only use original, unmodified Becker parts.
• Observe the country-specific regulations.
• Dispose of exhausted batteries properly. Only replace batteries with the same type.
• If the system is controlled by one or several appliances, the system's range of travel must always
be visible during operation.
• When connecting the control cables (safety extra-low voltages), only use cables with sufficient
electrical strength.
Important safety instructions for handling tubular drives with battery-
operated or solar power-operated control units.
• Keep children away from the control units.
• Device contains small parts that can be swallowed.
• Keep people out of the system’s range of movement.
• Only use in dry rooms (exceptions: SC861, SC561, SC211, SC431).
• Only use original, unmodified Becker parts.
• Observe the country-specific regulations.
• Dispose of exhausted batteries properly. Only replace batteries with the same type.
• If the system is controlled by one or several transmitters, the system’s range of travel must always
be visible during operation.