Installation manual

58
1. Programming the master
transmitter
Switch off the power supply on the radio
receiver (drive type PSF(+)) and then
switch it back on . Press the program-
ming button on the master transmitter
SWC241 until the drive clicks twice .
Note: Follow the instructions on pag-
es 52 and 53 to set the limit positions
for the PSF(+) drive.
Commissioning the motion sensor for awnings SC211
2. Programming the SC211
a.) Use the tool provided to turn the wind
threshold regulator clockwise to the
maximum setting . Then press the
programming button until the drive
clicks once .
b) Press the red programming button
of the SC211
until the tubular drive
clicks once .
c) Press the red programming button
again until the tubular drive clicks
twice .
SC211 control
1 x click
1 x click
2 x click
2 x click