Installation manual

54
Commissioning the radio-controlled Sun-Wind-Set with
handheld transmitter and SWS241 sensor
SWS241 control set
1. Programming the master
transmitter
a. Travel the curtain to a centre position
using the UP/STOP/DOWN toggle
switch.
b. Press the programming button on the
SWC510. The SWC510 is now in pro-
gramming mode for 3 minutes.
c. When in the programming mode,
press the programming button
on
the SWC441 until a confirmation
(the curtain shifts) is received.
Note: In order to recognise the
shift clearly, the curtain should be
situated between the limit positions.