Installation manual

51
Drives for sun protection
Information on the PSF(+) drive
PSF(+) drives with electronic limit
switching detect and program the re-
tracting limit position automatically if a
permanent stop exists.
If no stop exists, a limit switch point is
programmed.
PSF drives
PSF drives are used to operate screens,
awnings and conservatory shading.
PSF+ drives
PSF+ drives are used to operate cas-
sette awnings that require a higher clos-
ing torque. The cassette is then always
closed completely.
Programming the master
transmitter
Set the drive to programming mode
for 3 minutes by switching the power
on or by setting the radio switch to the
position
. Then press the program-
ming button on the master transmitter
until the drive clicks twice
(3 seconds
when installing new drives, 10 seconds
to overwrite a previously programmed
master transmitter).
Correcting the direction
If the drive is moving in the wrong direc-
tion, reverse the directional switch on the
drive.
Attention: The direction can only be
switched as long as no limit positions
have been programmed.
2 x click