Installation manual

5
Drives for roller shutters
If the drive does not react, RF(+) drives with integrated
radio receiver (up to 2002) or PRF+ drives (from 2003
onwards) have been installed.
Press the programming button
and keep it pressed.
Press the
button and keep it pressed.
Release the programming button
.
Press the programming button
again, until the drive
clicks twice.
If the drive clicks twice, PicoR+, RP(+) or PR+ drives
were installed.
If the drive does not react, a PicoR+ drive (up to 2007)
has been installed.
If the drive clicks once, it is a RP(+) or PR+ drive. You
have now programmed a limit position. Let the drive
turn twice from the limit position.
If the drive interrupts after one turn and then
continues, it is a RP(+) drive (from 2009 onwards).
Press the programming button
again.
If the drive runs without interruption, it is a PR+ drive
(from 2003 onwards).