Installation manual

48
Programming the limit positions with the programming
unit of type SE-B(+)
1. Programming the extend-
ing limit position with the
programming unit
Connect the wires of the tubular
drive to those of the same colour in
the programming unit.
Travel the curtain to the desired po-
sition and press the programming
button until the drive clicks once.
Note: If the drive clicks twice, an
extending limit position had al-
ready been saved, which has now
been deleted. In this case, press
the programming button again
until you hear one click.
2. Programming the retract-
ing limit position via the
programming unit
Travel the curtain towards the upper
stop until the drive stops automati-
cally.
SE-B(+) drives
1 x click