Installation manual

44
Setting the limit positions via the switches of type PS(+)
1. Delete both limit positions
with the switches
Set both switches to O and execute
a short drive command.
PS(+) drives
2. Programming the extend-
ing limit position
Travel the curtain to the desired po-
sition and switch the corresponding
switch from
O to .
3. Programming the retract-
ing limit position
Retracting limit position stop
Travel the curtain towards the
stop until the drive stops auto-
matically.
Retracting limit position point
Travel the curtain to the desired
position and change the corre-
sponding switch from
O to .