Installation manual

Drives

for sun protection

Travel the curtain downwards and press the program-

ming button again for 2 seconds.

If the drive does not react or if it clicks once, start re-

tracting the curtain until the drive stops at the limit po-

sition stop or at a pre-programmed switch-off point.

If the drive clicks twice, press the programming button

again until the drive clicks once. Then retract the cur-

tain until the drive stops at the limit position stop or at a

pre-programmed switch-off point.

Both limit positions are now programmed in the drive.

If the drive does not react, it is a type PS(+) or SEB(+).

Carry out the procedure for deleting:

Press the programming button

and keep it pressed.

Press the

button and keep it pressed.

Release the programming button

Press the programming button

again, until the drive

clicks twice.

Press the programming button

for 2 seconds twice

consecutively.

If the drive clicks once and then twice, it is a type

SEB(+) (from 2003 onwards).

If the drive clicks only once, it is a type PS(+) (from

2003 onwards).

Press the programming button

again for 2 seconds.

If the drive clicks twice, it is a type S(+) (up to 2003).