Installation manual

32
How to identify the type of drive:
The drives can be identified using the programming
unit, even when they are installed. Connect the wires
in the connecting cables of the drive to the wires of the
same colour in the Becker programming unit. Perform
the following steps one after the other.
Press the programming button
for 2 seconds.
If the drive produces a loud noise and the tube does
not turn, the drive is a type M. Replace the program-
ming unit immediately with one that is suitable for an
M drive.
If the drive does not react or if it clicks once or twice, it
is an S(+), PS(+), SEB(+), SF(+) or PSF(+) drive.
Possible drive types:
Type M: Drive with mechanical limit switching
Type S(+): Drive with electronic limit switching (1997-2003)
Type SF(+): Drives with electronic obstruction detection and radio receiver
(2000-2003)
Type PS(+): Drives with electronic limit switching and point to point programming
(from 2003 onwards)
Type SEB(+): Drives with electronic limit switching and automatic reversal (fabric
stretching) in the extending limit position (from 2003 onwards)
Type PSF(+): Drives with radio receiver and point to point programming
(from 2003 onwards)
+ means: higher closing force for cassette awnings
Press the travel button to move in both directions.
If the drive does not react, it is a drive with integrated
radio receiver of type SF(+) (up to 2002) or type PSF+
(from 2003 onwards) .
Which type of sun protection drive has been installed?
General