Installation manual

19
Drives for roller shutters
Information on the RP(+)drive
RP(+) drives with electronic limit switch-
ing detect and program both limit posi-
tions automatically. If no stops exist,
limit switch points are programmed.
In order for the drive to detect the upper
limit position automatically, a defined
stop must be present (angled strip or
mechanical stop).
Installation with springs of type RP
No more than one roller shutter bar
should jut out over the intake guide. In
the lower limit position, the springs must
counteract the tube’s rotary motion. The
springs should be mounted 30 cm apart
from one another.
Installation with anti-lifting
devices of type RP+
The anti-lifting devices must be securely
engaged and be pressing the roller shut-
ters onto the window sill.
The limit positions can be set using any
operator control.
Limit positions are deleted using the
programming unit.
Connect the wires in the connecting ca-
ble of the drive to the wires of the same
colour in the programming unit.