Installation manual

17
Drives for roller shutters
1. Programming the upper limit
position
First, travel the roller shutters towards
the upper limit position until the drive
switches off automatically.
Note: When the shutters close for
the first time (installation run), the
drive uses less force for safety rea-
sons. If the force is configurated
close to the limit, the drive may
stop before reaching the upper limit
position. After resetting (deletion
of the limit positions), the drive is
started again until it reaches the
upper limit position.
Programming the limit position when installing with
anti-lifting devices of type R+
2. Programming the lower limit
position
Then travel the roller shutters towards
the lower limit position until the drive
switches off automatically.
Deleting the limit positions using
the programming unit
Press the programming button until the
drive clicks twice.
2 x click