Installation manual

13
Drives for roller shutters
3. Programming the travelling
distance
Travel the roller shutters towards the
upper limit position again, without in-
terruption, until the drive switches off
automatically.
This time, the drive learns the distance
between the limit positions and auto-
matically concludes the programming
phase.
4. Deleting the limit positions
using the programming unit
Press the programming button and
keep it pressed.
Press the
button and keep it
pressed.
Release the programming button
Press the programming button again,
until the drive clicks twice.
For drives that were built before 2004,
press the programming button
until
the drive clicks twice.