Installation manual

12
Programming the end positions for type PicoR+
1. Programming the upper limit
position
First, travel the roller shutters towards
the upper limit position until the drive
switches off automatically.
Note: When the shutters move up-
wards for the first time (installation
run) the drive uses less force for
safety reasons. If the force is con-
figurated close to the limit, the drive
may stop before reaching the upper
limit position. After resetting (dele-
tion of the limit positions), the drive
is started again until it reaches the
upper limit position.
2. Programming the lower limit
position
Now travel the roller shutters to the
desired lower limit position.
(If anti-lifting devices or rigid safety
springs are installed, travel the roller
shutters downwards until the drive stops
automatically.)
PicoR+ drives