User Guide

120
Using Navigation
The current time is displayed. After 8 seconds, the
system returns to the route guidance display.
The clock settings can be accessed by pressing and
holding the right rotary control . See ”Setting
time” on page 124.
Requesting current position
During route guidance, the current position can be
requested.
Press multifunction button .
The current position, with street name (if availa-
ble), latitude and longitude, elevation above sea
level (in 50 m increments) and the number of sat-
ellites received will be displayed.
Pressing the right rotary control will return you
to the route guidance display.
Press multifunction button , to store the cur-
rent position in the ”last destination” memory.
Return to the route guidance display by pressing
the right rotary control or waiting a short time.
Calling up traffic announcements
All the traffic announcements received or those
relevant for the route can be called up.
Press the multifunction button . All received
traffic announcements will be displayed.
Press the multifunction button . The traffic
announcements relevant for the route are dis-
played.
If no traffic announcements are available, the mul-
tifunction buttons and are not dis-
played.
The list is sorted. The list displays warning mes-
sages (e.g. wrong-way drivers) first, followed by
traffic problems (e.g. accidents) and lastly traffic
problems due to road construction.
If more than one traffic problem exists on a road,
the number of problems is shown by
2x..., 3x...
etc.
To display the entire text of the traffic announce-
ments, select the desired entry with the right rotary
control .
Traffic announcements will be shown for the se-
lected road.
If several announcements (e.g. 3) have been re-
ceived, the individual announcements are indi-cat-
ed by
1/3, 2/3 and 3/3. The announcements
displayed can be scrolled through by turning the
right rotary control .
The announcements can also be read out. For this
purpose, press the right rotary control for more
than 2 seconds.
Pressing the right rotary control returns to the
list of traffic announcements.
Note:
If the reception of traffic announcements is not
possible for technical reasons, or will
be shown in the display.