User Guide

109
Using Navigation
options can be combined freely.
•
Fast route
With this setting, the shortest possible travel
time to the destination is calculated.
•
Dyn. route RDS
The route is calculated taking into account the
traffic announcements received.
Note:
Dynamic route guidance is not currently
possible in all countries.
When new route calculations are made with
dynamic route guidance activated, the
navigation system may request the Navigation
CD (if the Navigation CD is not already
inserted).
If dynamic route guidance is active, the routes
are calculated using the "Fast Route" setting.
Further information on Dynamic Route can be
found in section ”Dynamic Route Guidance” on
page 118.
•
Dyn. route TDS
TDS is an additional dynamic navigation op-
tion.
At the time of going to press, this function was
still undergoing the release/certification proc-
ess. You will be notified separately once this
process has been completed.
•
Short route
With this setting, the shortest possible route to
the destination is calculated.
Note:
For larger cities or urban areas, the setting
"
Short route" is recommended.
•
Avoid Ferry, Avoid Motorway, Avoid
Toll
and Avoid Tunnel
provides options for avoiding bridges, ferries,
tunnels or toll roads.
This means that when the ( ) function is
active, the route will be calculated e.g. without
tunnels where possible.
Note:
In the case of long journeys, motorways are in-
cluded in route calculation even where
Avoid
Motorway
is activated.
•
Private route and Bussiness route
This function deals with settings for a driver's
log.
At the time of going to press, this function was
still undergoing the release/certification proc-
ess. You will be notified separately once this
process has been completed.
Destination memory
The destination memory contains personally
stored destinations. It is not mandatory to store any
destinations in the destination memory. However,
it saves repeated manual entry if the destination is
required again at a later date.
Calling up a destination stored in the
destination memory
Using the right rotary control, select Dest.
memory
in the main Navigation menu or in anoth-
er entry menu and press the control to confirm.
Select the desired destination using the right rotary
control and press the control to confirm.
Route calculation begins.
Additional information about the destination can
be called up before confirming the selection by
pressing the left rotary control .