Operating Manual

>>> NAVIGATION MODE
> D
> GB
> F
> I
> E
> P
> NL
> DK
> S
> N
> FIN
> TR
> GR
> PL
> CZ
> H
> RUS
Clearing a blocked route
You can clear the blocking of a road
ahead.
> In the My Route menu, select
Block
ahead
.
> Select
Clear blockings.
The blocking is cleared and the system
performs a route recalculation.
Map display
You can select whether the map is to be
displayed in 3D or 2D mode, in a split
screen with 3D or 2D display or in arrow
mode.
In addition, you can adjust in 3D mode
the viewing angle of the map and specify
whether or not 3D models of buildings
and 3D landmarks should be displayed.
> Select
Map in the map toolbox.
> Select with
Full map, Map with Turn-
By-Turn
, Split screen or Turn-By-Turn
the basic display.
> Select with
2D or 3D the mode of the
map display.
> For 3D mode, select whether or not 3D
places of interest available should be dis-
played (yes or no ) with
3D-
Landmarks
. The display of the models
of buildings is switched on and off si-
multaneously.
> For 2D mode, select whether the map
should always be orientated to the di-
rection of travel ( ) or to the north
() with
Heading up.
> Switch Autozoom on or off
with
Autozoom.
> For 3D mode, select
Map tilt angle to
set the viewing angle of the map.
> Select between the viewing angles
Higher, Normal and Lower.
> Confirm your settings by selecting
Done.