Operating Manual

37
NAVIGATION MODE >>>
> D
> GB
> F
> I
> E
> P
> NL
> DK
> S
> N
> FIN
> TR
> GR
> PL
> CZ
> H
> RUS
Point of interest on the route
During route guidance, you can display
the points of interest located on the route.
You can specify which categories of points
of interest should be displayed, and you
can also choose whether to display only
the nearest POIs, all the POIs on the en-
tire route, or only POIs near the destina-
tion.
> In the My Route menu, select
POI on
route
.
The nearest points of interest for the three
selected categories are displayed.
The distance indicated shows the distance
to the point of interest. The points of in-
terest are displayed on the map on the left-
hand side.
After selecting one of the points of inter-
ests you can start route guidance to it.
Setting categories
> Select
More....
> Select
Select POI categories.
> Then select the desired categories.
Point of interest near destination/on
complete route
> Select
More....
> Select
Search POI on route.
or
> Select
Search POI near destination.
> Select the desired category.
> Then select the desired point of interest.
> Start navigation to the selected point of
interest.
Blocking a route
You can block a stretch of road ahead.
This determines a certain stretch of road
that should not be used. The Becker®
MAP PILOT then attempts to calculate a
diversion.
> In the My Route menu, select
Block
ahead
.
> Select to select the desired length of
the block.
> Select to select the start of the block.
> Select to activate the block.
The blocking is activated and the system
performs a route recalculation.
Note:
The selected length of the block is only
an approximation since the actual dis-
tance blocked depends on the availability
of an exit.
1
2
3
1
2
3