User Guide

21
General operation
In this example you can see the settings
for the front loudspeakers.
X Turn the rotary control/push button
to select the required value.
Compression
This function enables you to switch the
reduction of the dynamic range of the
audio signal on/off.
X Select &RPSUHVVLRQ in the sound set-
tings.
X Press the rotary control/ push button
to switch the function on ( ) or
off ( ).
Reset settings
You can reset all sound settings to the
default settings.
The following settings are reset to the
relevant default value:
•
(TXDOLVHU: All default settings are reset
to the initial value. The user-defined
setting is reset to zero.
•
%DODQFHIDGHU to centre setting
•
/RXGQHVV to off
• %HFNHUVXUURXQG to off
•
6XEZRRIHU to RII.
•
&URVVRYHU front and rear loudspeakers
to
RII, subwoofer to 100 Hz.
• &RPSUHVVLRQ to RII.
X Select 5HVHW VHWWLQJV in the sound set-
tings.
X Select <HV to reset the sound settings
or
1R to continue without making any
changes.
Select
<HV to reset the sound settings.
Mute
You can switch your Cascade to mute,
i.e. switch off the sound from the current
radio/media source.
However, navigation announcements,
traffic announcements (if TP has been
activated) and other voice announce-
ments on the Cascade continue to be
transmitted unaffected.
X Press the rotary control/push button
and hold it down for at least
2 seconds.
Example of muted radio mode.
Example of muted media mode.
1026
1027
1020
1021
1022