User Guide

133
Settings
Repeating a voice announcement
If the function has been switched on and
route guidance is active, the last naviga-
tion announcement can be repeated or an
updated navigation announcement out-
put by pressing .
X Select 5HSHDWYRLFHDQQRXQFHPHQW in the
voice mode settings.
X Turn the rotary control/push button
to switch the function on ( ) or off
().
System settings
You can configure various basic settings
on your Cascade to meet your require-
ments in the system settings.
The following possible settings are
available:
For
$XGLR:
• Setting for speed-dependent increase
in volume with
6SHHGGHSHQGHQWYROXPH
• Using ,QVWDOODWLRQ SRVLWLRQ RI PLFURSKRQH,
you can specify whether your vehicle
is a left-hand drive or right-hand drive
vehicle.
• Setting for acoustic signal volume
with
9ROXPHRIZDUQLQJWRQHV
• You can use 'LVSOD\ YROXPH to select
whether a change in volume should be
displayed in graphics format.
• Setting for the volume level of digital
to analogue audio sources with
'LJLWDO
OHYHO
• You can use 6XSSRUWVSDUNLQJDLG to se-
lect whether the audio volume is to be
lowered when the reverse gear is en-
gaged.
For
'LVSOD\:
• Setting display brightness with
'LVSOD\
EULJKWQHVV
• Setting display colour using &RORXUV.
• You can use
'D\QLJKWGHVLJQ to config-
ure the settings for changeover be-
tween day and night design.
Other settings:
• Using
([WHUQDOGHYLFH, you can specify
whether an AUX source or an external
hands-free unit is connected to the
Cascade instead of a CD changer.
• You can use
5HVHWIXQFWLRQV to reset the
Cascade to the factory settings.
• You can use 'DWDEDFNXS to backup the
address book data or load previously
saved data back onto your Cascade.
• You can use 'LUHFWLRQRIURWDU\DFWXDWRU
to specify the direction in which lists
and menus are scrolled when the
rotary control/push button is turned.
7013