User Guide

Subject to errors or technical changes 38 Copyright by Becker GmbH, D-76303 Karlsbad
Installation Guide
6. Installation of the hands-free microphone
The hands-free microphone should be placed in the vehicle to allow optimal recognition of the speaker’s voice. Possible
positions in the vehicle for the microphone can be seen in the following diagram.
)
The installation position should be as far away from the loudspeakers as possible. If problems occur, different
positions should be tested. In order to pick up as little background noise as possible, the microphone has a
narrow pick-up angle and must consequently be directed towards the driver.
Affixing the hands-free microphone to a flat and smooth surface can be accomplished with the adhesive strip E (Clean
adhesion surfaces). If the microphone is to be affixed to a rough or uneven surface, the screw-on plate G should be affixed
first with the screw F (To avoid risk of damage, please pay attention to screw length). Subsequently, affix the microphone
to the screw-on plate G with the adhesive strip E. The connection of the hands-free microphones takes place in socket C
of the OnlinePro.
A: Optimal installation position
B: Alternative installation position
C: Less suitable installation position
D: Speaking direction on microphone
E: Adhesive strip for affixing to smooth surfaces
F: Screw for fastening the screw-on plate
G: Screw-on plate for affixing to rough or uneven surfaces.