User Guide

Subject to errors and technical changes 47 Copyright by Becker GmbH, D-76303 Karlsbad
Installation Guide
• Remove grease from flex cable and connect dog to flex cable.
Using a suitable installation tool, press the dog onto the flex cable
(Figure 9).
)
When pressing in, ensure that the dog is securely positioned
and that it runs smoothly.
• Pull the hose sleeve and nut as far as possible in the direction of the
dog, to achieve approx. 1-2 mm play (Figure 10).
Slightly squeeze the hose sleeve with pliers. Wrap with isolating
tape to secure (Figure 11).
• Screw the connecting piece and the speed sensor into the cable
(Figure 12).
• Electrically connect the speed sensor using the extension cable
from VDO (part number: 2152.90 30 0100).
Wire connections for the speed sensor
Brown - earth (terminal 31)
Black - power supply (terminal 15), 9 - 16V, 30 mA
Blue/red - signal for socket A pin 1
Figure 9
Figure 10
Figure 12
Figure 11