User Guide

Subject to errors or technical changes 46 Copyright by Becker GmbH, D-76303 Karlsbad
Installation Guide
Recommended tools: Cable installation tool for speedometer cables
from VDO, Order No: 1999.10.13.000.110
If you require vehicle-specific parts, please consult the vehicle
manufacturer or your nearest VDO branch.
• Using a metal saw, cut into the cable approx. 1 mm at a right angle
to the profile and break off (Figure 3).
• Then cut the cable in the centre with side-cutting pliers
(Figure 4).
)
For protective hoses with wire netting, the hose and flex
cable can be cut directly with the side-cutting pliers.
• Shorten the protective hose again at both ends up to the plastic
sheathing. Check whether the ends of the flex cable still engage in
the speedometer and the gearbox.
• Shorten the inner cable to a projection of 13 mm (Figure 5).
• Connect the union nut and hose sleeve (Figure 6) and push onto the
hose ends (Figure 7).
• Connect friction washer to dog (Figure 8).
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8Figure 8