User manual

-50-
3.2.7. Monitoring
3.2.7.1. Port Status
This page provides current status of every port that depends on user’s setting
and the negotiation result.
State: Display port statuses: disable or enable. “Unlink” will be treated as “off”.
Link Status: Down means “No Link”; Up means “Link up”.
Auto Negotiation: Display the auto negotiation mode: auto/force/nway-force.
Speed status: Display 1000Mbps or 100Mbps or 10Mbps speed, port 1-8 are
10/100Mbps, Port 9-10 are 10/100/1000Mbps."
Duplex status: Display full-duplex or half-duplex mode.
Flow Control: Display the flow control state
Full: Display the flow control is enabled or disabled in full mode.
Half: Display the backpressure is enabled or disabled in half mode.
Rate Control: Display the rate control setting.
Ingress: Display the port effective ingress rate of user setting.
Egress: Display the port effective egress rate of user setting.
Port Security: Display the port security is enabled or disabled.
BSF: Display the port broadcast storm filter control is enable or disable.
Jumbo Frame: Display the jumbo frame is supported or not for the port.
NOTE: You can click the Browser’s Refresh button or press <F5> to update to
the latest status.
3.2.7.2. Port Statistics
The following information provides a view of the current status of the whole
unit.
Press Reset button to clean all count.