User manual

-12-
Module Info
All information in this field is read only; user can’t modify its contents. It is only
to display the module port information.
MISC CONFIG
This page is to provide miscellaneous settings:
 MAC Address Age-out Time: Type the number of seconds that an
inactive MAC address remains in the switch's address table. The valid
range is 6~1572858 seconds. Default is 300 seconds. The value is a
multiple of 6.
 Turn on port interval: Set the interval time between turning off and
turning on when flooding CPU on this port. That’s to say, when flooding
CPU’s rate is faster than 3M this port will be disable, After turn on port
interval time later it will be enable automatically.
 Broadcast Storm Filter Mode: To configure broadcast storm control,
enable it and set the upper threshold for individual ports. The threshold is
the percentage of the port's ingress bandwidth used by broadcast traffic.
When broadcast traffic for a port rises above the threshold you set,
broadcast storm control becomes active. The valid threshold value are 1/2,
1/4, 1/8, 1/16, and off.
 Broadcast Storm Filter Packets Select: To select broadcast storm Filter
Packets type. If no packets type by selected, mean cannot filter any
packets .The Broadcast Storm Filter Mode will show OFF.
 Collisions Retry Forever: In half duplex, collision-retry maximum is 16,
32, or 48 times and packet will be dropped if collisions still happen. In
default (Disable), system will retry forever if collisions happen.
 Hash Algorithm: Select Hash Algorithm.
 IP/MAC Bing: Enable or disable SMAC and SIP binding.
 802.1x Protocol: Enable or disable 802.1 x protocols.
NOTE: Before you enable 802.1x or IP/MAC Binding, you should enable them
in this page