Users Manual Part 2

Device Configuration
VPN – OpenVPN (OpenVPN Server – TAP (Serve-Bridge)
166
BEC 4700A / 4700AZ User Manual
 TAP (Ethernet Over OpenVPN) in Server-Bridge Mode
◆ Bridge: No – Using its own client IP address.
◆ Local Service Port: Port 1194 is the default assigned port for OpenVPN.
◆ Protocol: OpenVPN can run over either UDP or TCP transports. Select the protocol.
◆ Tunnel Network IP Address / Netmask: Enter a virtual IP address and Netmask for this
tunnel. NOTE: The virtual IP addresses cannot be existed or used in both networks.
◆ Local IP Address / Netmask: Enter local LAN network IP address and Netmask.
 TAP (Ethernet Over OpenVPN) in Bridge mode
◆ Bridge: Yes – Can use local DHCP server on LAN to assign IP address to VPN clients.
◆ Local Service Port: Port 1194 is the default assigned port for OpenVPN.
◆ Protocol: OpenVPN can run over either UDP or TCP transports. Select the protocol.
Certification
Local Certificate / Trusted CA Index: OpenVPN mutually authenticate the server and client
based on certificates and CA. Select a certificate and CA.
To import certificates and CAs, go to Maintenance >> Certificate Management to upload files.
Otherwise, select Default certificate and CA.