Users Manual Part 2

Device Configuration
VPN – PPTP Client
142
BEC 4700A / 4700AZ User Manual
Connection Type: Select Remote Access for single user, Select LAN to LAN for remote gateway.
Server IP Address: Enter the WAN IP address of the PPTP server.
Remote Network IP Address: Enter the subnet IP of the server/host LAN network.
Remote Network Netmask: Enter the Netmask of the server/host LAN network.
Fixed IP: Specific and reserve a LAN IP address from the remote PPTP server. Click Enable then
enter the request IP address.
Active as Default Route: Enabled to let the tunnel to be the default route for traffic, under this
circumstance, all packets will be forwarded to this tunnel and routed to the next hop.
DMZ: Specific an internal DMZ host to add an additional layer of protection to the network. All received
incoming packets will first go through the Virtual Server list, if no service redirection required, then
packets can get forwarded to the DMZ host. Click Enable then enter the DMZ IP address.
Virtual Server: Click Enable to enable redirection of Internet packets.
Virtual Server Index: Index marking for each rule up to maximum of 4.
Protocol: Choose the application protocol.
Start / End Port Number: Enter the start / end port number of the local application (service).
(Example: Start / End: 1000 or Start: 1000, End: 2000).
The starting greater than zero (0) and the ending port must be the same or larger than the starting
port.
Local IP Address: Enter the local IP address of the default start/end port of the application / service.
Click Save to apply settings.