Users Manual Part 1

Device Configuration
Interface Setup – Internet (WAN on Ethernet)
65
BEC 4700A / 4700AZ User Manual
❖ EWAN
Bandwidth: Traffic/data control from WAN to LAN (Downstream) and LAN to WAN (Upload).
Status: Select Activate / Deactivated to enable / disable the WAN service.
IPv4/IPv6
IP Version: Choose IPv4, IPv4/IPv6, or IPv6 based on your environment. If you don’t know which one
to choose from, please choose IPv4/IPv6 instead.
ISP Connection Type
ISP: Select the encapsulation type your ISP uses.
 Dynamic IP: Select this option if your ISP provides you an IP address automatically.
 Static IP: Select this option to set static IP information. You will need to enter in the Connection
type, IP address, subnet mask, and gateway address, provided to you by your ISP. Each IP
address entered in the fields must be in the appropriate IP form. IP address from by four IP
octets separated by a dot (xx.xx.xx.xx). The Router will not accept the IP address if it is not in
this format.
 PPPoE: Select this option if your ISP requires you to use a PPPoE connection.
802.1q Options
802.1q: When activated, please enter a VLAN ID.
VLAN ID: It is a parameter to specify the VLAN which the frame belongs. Enter the VLAN ID
identification, tagged: 0-4095.
Dynamic IP Address (If selected as WAN Connection Type; otherwise, skip this part)