User manual
59
You should specify at least one condition below to set a MAC lter prole. If multiple conditions are
specied, all of them take effect.
Protocol Type: Select which protocol this lter will be applied to from the drop-down menu.
Destination MAC Address: Enter the destination MAC address this lter will be applied to. The
format of MAC address could be: xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-xx-xx.
Source MAC Address: Enter the origin MAC address this lter will be applied to. The format of
MAC address could be: xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-xx-xx.
Frame Direction: Select the frame ow direction from the listbox: LAN to WAN, WAN to LAN, or
both directions.
WAN Interfaces (Congured in Bridge mode only): Select the WAN interface.
Click Apply/Save to set the new settings and you will be returned to the Incoming IP Filtering page.
Remove: To delete the IP ltering rule from the table, check Remove checkbox then click Remove
button to delete the selected item.