User manual

BEC 6200WZL 4G/LTE Cellular Broadband Router

Step 2: WAN / Internet Connection Setup

Select the appropriate WAN protocol then fill out the information provided by your ISP in all

relevant parameters. For 3G/4G_LTE connection, if your Service Provider is not on the list,

please select Other and fill out all of the appropriate fields.

Step 3: Setup Wireless Connection

Step 4: Saving Configuration

Wait for 10 - 20 seconds for the router to establish an Internet connection.

If no responses for more than 30 seconds please check the SIM Card connection or/and

information is/are being input properly.

Step 5: Quick Start Wizard Complete

“Success!” message will be shown if the Internet connection is ready to go.

If not, please check your WAN, Internet Connection, setup again.

Please see the relevant sections of User Manual for detailed information.

Troubleshooting

1. None of the LEDs are on when you turn on the router.

Check the connection between the adapter and the router. If the error persists, you may have

a hardware problem. In this case you should contact technical support.

WLAN Service: select Enable

ESSID: Assign an unique name

Channel ID: pick from 1~11

Security Mode: select a mode

- Disable (No security)

- WPA

- WPA2 (Most secure one)

- WPA / WPA2 (auto detect WPA

mode with wireless clients)

- WEP (Less secure one)

Security Parameters: key for wireless

authentication

- WPA / WAPA2 Share Key: Assign a

key between 8 ~ 63 characters.

- WEP: select Open System, use

default WEP Key 1 then assign 26

Hex codes

Next Step: click Continue